Here are a few tips and tricks for using the Climate Action Kit.

Important Notes

  • Thread the connector cables through the holes in the building blocks for better cable management.
  • You can connect components together in a line, or ‘daisy chain’ when building (Sensor Components only).
  • You can easily switch Sensor ports on the Breakout Board without affecting your code – i.e., Sensors do not need to be programmed to specific ports. However, Servo Motors do need to be programmed to specific ports (see ‘Understanding Servo Motors’ section in this course).
  • Use the small cable connector piece to attach the cables together.
  • Customize your projects by using craft materials and the butterfly clips.
  • Always make sure the Water Pump is stored away properly. When you’re finished with the water pump, allow it to run out of water for a few seconds to clear the pump and tubing. Then, allow it to air dry overnight before storing it away.

Next up, we’ll walk through the online platform where you’ll find all of the lesson content and tutorials that accompany the Climate Action Kit.